input parameter conditions min. typ. max. units input voltage range 85 265 vac input frequency 47 440 hz input current see model selection guide inrush current 115 vac 15.0 a pk 230 vac 30.0 emi meets cispr pub. 22/fcc class b safety ground leakage current 115 vac 0.1 ma 230 vac 0.3 output parameter conditions min. typ. max. units output voltage see model selection guide output current see model selection guide output voltage accuracy ?.0 ?.0 % line regulation v in = min to max ?.2 ?.0 % load regulation, single output i o = min to max ?.5 ?.0 % load regulation, dual, triple aux output i o = min to max ?.5 ?.0 % ripple & noise (20 mhz) 5.0 vdc output 1.5 1.8 %v p-p of v o all other outputs 0.8 1.0 hold-up time 115 vac, 60 hz 20 msec temperature coef cient ?.02 %/? over voltage protection zener diode clamp 120 % of v o short circuit protection, note 3 continuous (autorecovery) overload protection, note 4 typ. 120% to 180% of output power general parameter conditions min. typ. max. units isolation voltage input to output 3,000 vac isolation test voltage input to output, flash tested for 60s 4,700 vac isolation resistance 500 vdc 100 m emi/rfi conducted en 55022 level b emc compliance electrostatic discharge (esd) iec/en 61000-4-2 level b rf field susceptibility iec/en61000-4-3 electrical fast transients/bursts on mains iec/en 61000-4-4 level 3 2 kv surge iec/en 61000-4-5 level 3 1kv/2 kv switching frequency 100 khz environmental parameter conditions min. typ. max. units operating temperature range ambient -25 +25 +71 ? storage temperature range -40 +85 ? cooling free air convection (see derating curve) humidity rh, non-condensing 95 % physical case size, chassis mount 3.81 x 2.13 x 0.92 inches (96.7 x 54.0 x 23.3 mm) case size, din rail option 3.81 x 2.13 x 1.35 inches (96.7 x 54.0 x 34.3 mm) case material non-conductive plastic& fiberglass (ul94-v0) weight 5.69 oz (162g) reliability speci cations parameter conditions min. typ. max. units mtbf mil hdbk 217f, 25?, gnd benign 280 khours safety standards ien 60950, iec 60950 safety approvals ien 60950, iec 60950 safety class iec 61140 class ii chassis mount, 15w single, dual & triple out ac/dc power supplies key features: 15w output power universal 85-265 vac input en60950 approved single, dual & triple outputs meets en55022 b meets iec safety class ii chassis mount case c hi m t 1 5 w MPM-15CM series electrical speci cations speci? cations typical @ +25c, 230 vac input voltage & rated output current, unless otherwise noted. speci? cations subject to change without notice. micropower direct 292 page street suite d stoughton, ma 02072 usa t: (781) 344-8226 f: (781) 344-8481 e: sales@micropowerdirect.com w: www.micropowerdirect.com din rail mounting kit available! www.datasheet.net/ datasheet pdf - http://www..co.kr/
model selection guide mechanical dimensions , chassis mount notes: all dimensions are typical in inches (mm) tolerance x.xx = 0.01 ( 0.25) pin single dual triple 1 ac-neutral 2 ac-line 3 +vo +vo +vo 2 4nc nc +vo 1 5 -vo common common 2/3 6nc nc -vo 1 7 nc -vo +vo 3 nc = no connection pin connections to l erance x . micropower direct www.micropowerdirect.com 292 page street ste d stoughton, ma 02072 tel: (781) 344-8226 fax: (781) 344-8481 e-mail: sales@micropowerdirect.com derating curve notes: 1 . load regulation is measured for an output change of 0% to 100% at nominal input line. for multiple output models, the loads are balanced. 2. operation at no-load will not damage these units. however, they may not meet all speci cations. 3. output short circuit protection is provided by a ?iccup mode circuit. the unit recovers automatically when the fault condition is removed. 4. output overload protection is provided by a fold back current limiting circuit. 5. for triple output models, the maximum capacitive load for 5 vdc outputs is 2,200 f. for all other outputs it is ?,500 f. 6. the MPM-15CM series includes a built-in 2.0a/250 vac fuse. it is recommended that an external 1.5a slow blow fuse also be used on the input for protection. other output combinations are available contact the factory for details at: sales@micropowerdirect.com model number input output 1 (vout 1) output 2 (vout 2) output 3 (vout 3) capacitive load (?, max) ef ciency (%, typ) current (a) voltage (vdc) current (a) voltage (vdc) current (a) voltage (vdc) current (a) 115 vac 230 vac max. min. max. min. max. min. mpm-15s-05cm 0.290 0.14 5.0 3.000 0.300 3,900 75 mpm-15s-12cm 0.275 0.14 12.0 1.250 0.125 2,200 79 mpm-15s-15cm 0.275 0.14 15.0 1.000 0.100 2,200 79 mpm-15s-24cm 0.275 0.14 24.0 0.625 0.063 2,200 79 mpm-15s-48cm 0.273 0.14 48.0 0.310 0.030 1,000 79 mpm-15d-12cm 0.275 0.14 +12.0 +0.625 +0.063 -12.0 -0.625 -0.063 ?,500 79 mpm-15d-15cm 0.275 0.14 +15.0 +0.500 +0.050 -15.0 -0.500 -0.050 ?,500 79 mpm-15t-0512cm 0.290 0.14 5.0 2.000 +0.200 +12.0 +0.200 +0.020 -12.0 -0.200 -0.020 note 5 74 mpm-15t-0515cm 0.284 0.14 5.0 1.80 +0.200 +15.0 +0.150 +0.015 -15.0 -0.150 -0.015 note 5 74 a din rail mounting kit is available contact the factory for details at: sales@micropowerdirect.com www.datasheet.net/ datasheet pdf - http://www..co.kr/
|
